|
Lightweight handheld test solution for Metro Ethernet and IP services
The SunLite GigE is a rugged, compact and lightweight handheld test solution with long battery operation hours for the installation and maintenance of Metro Ethernet and IP services. A complete set of testing capabilities makes the SunLite GigE ideal for the field technician who needs to verify end-to-end transport of Gigabit Ethernet/IP traffic, perform BER tests, determine throughput, link utilization, latency, packet jitter, and IP connectivity.
The intuitive graphical user interface of the SunLite GigE, along with the straightforward creation and sharing of test profiles, allow technicians with limited Ethernet or IP testing experience to verify performance parameters for Gigabit Ethernet services. The wide range of test functionalities of the SunLite GigE provides all of the tools needed for verifying Service Level Agreements (SLAs) between service providers and their customers.
|
|
 Full 10/100/1000 Mbps and GigE line rate traffic generation
Performs throughput, latency, frame loss, and back-to-back tests per RFC 2544
Packet Delay Variation (packet jitter) per RFC3393
BER testing at Layer 1, Layer 2, and Layer 3 (IP) for Gigabit Ethernet and IP services
IP verification with Ping, Traceroute, ARP scan, Echo Response, and IP Throughput across a routed network
Generate up to 8 independent traffic flows with different MAC address, VLAN tag, MPLS TAG, IP address, payload and bandwidth configurations
Class of Service (CoS) (via VLAN P-bit) and IP Type of Service (ToS)/DSCP traffic prioritization settings
Aggregate and per-stream measurement statistics
RFC2544 benchmarking test
10/100/1000BASE-T and 1000BASE-X dual media test interfaces
Control/Respond Loopback feature to loop-up/down a far end STT, MTT Ethernet test modules or GigE Responder
Test Profiles for fast and efficient test set configuration and operation
USB port for test profiles/reports management and transfer
|
|
MetroEthernet-Forum
